Nvidia 754 User Manual download pdf (Page 38)

BIOS

Page 4-8

Row cycle time (Trc)

This field specifies the Row Cycle Time. RAS# active to RAS# active or auto

refresh of the same bank.

Options: Auto, 7T ~ 21T.

Row refresh cyc time (Trfc)

This field specifies the Row Refresh Cycle Time. Auto-refresh active to RAS# or

RAS# to auto refresh.

Options: Auto, 9T ~ 23T.

Row to Row delay (Trrd)

This field specifies the Row to Row delay of different banks.

Options: Auto, 2T ~ 4T.

Write recovery time (Twr)

This bits specifies the Write Recovery Time. Called Trd1 by Samsung, measures

when the last write datum is safely registered by the DRAM. It measures from the

last data to precharge.

Options: Auto, 2, 3.

Write to Read delay (Twtr)

This bits specifies the Write to Read delay. Samsung Calls this Tcd1r (last data in

to read command). It is measured from the rising edge following the last non-

masked data strobe to the rising edge of the next Read Command. (Jedec spec this

as exactly one clock).

Options: Auto, 1, 2.

Read to Write delay (Trwt)

This field specifies the Read to write delay. This is not a DRAM specified timing

parameter but must be considered due to routing latencies on the clock forwarded

bus. It is counted from first address but slot which was not associated with part of

the read burst.

Options: Auto, 1 ~ 6.

Refresh Rate (Tref)

This field specifies the number of clock cycles between refresh.

Options: Auto, 15.6us, 7.8us, 3.9us.

Read Preamble Value

Options: Auto, 2.5ns to 9.5ns in 0.5ns increments.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 77 78

No comments

Nvidia 754 User Manual Page 38